BSA GEAR SELECTOR SHAFT WITH FORKS. B, M, PLUNGER, RIGID, GENUINE NOS, 66-3288

BSA GEAR SELECTOR SHAFT WITH FORKS. B, M, PLUNGER, RIGID, GENUINE NOS, 66-3288

Replaces OEM Part No: 66-3288

1 piece (assembly). Gear control selector shaft assembly. Correct for M20 but can also be used to replace for B and M series 1938-1962 plunger and rigid frame models. The only difference is that this item has the large heavy duty control shaft pegs which guide the forks.

B31, B32, B33, M20, M21, M33 etc.

When you receive this part please be aware that it is not seized. It is covered in a factory protective hard layer film that will need to be soaked in paraffin, thinners or diesel etc and then cleaned before use. You may also find the selector forks will free up easier with the use of heat.

This is a genuine part, never used, signs of shelf wear may be evident.

Please use the part numbers to verify specifics for your application.

Genuine New Old Stock. Very rare original parts.

Please note:

Absolutely no returns, exchanges or refunds. This item, as stated on the listing, is new old stock. This generally retails for over $270.00 anywhere in the world (if you can find them). We have dropped the price significantly to allow for any faults if any. We cannot be held responsible for the condition of this item especially considering the fact that it is VERY OLD and are covered with hard protective film.

Made In England.